Why does my heat surge shut off?

Why does my heat surge shut off?

A buildup of dirt or dust can cause the heating elements to overheat, and in turn cause the fireplace to turn off. To check if your electric fireplace has excess dust, turn off your fireplace at the wall and unplug it from the socket. Allow the fireplace to cool down before attempting to check for dust or dirt.

How do I contact heat surge?

[email protected].

How do you reset a heat surge electric fireplace?

Push the ‘Reset Button’ located on the top left section of the back of the unit. This button resets the built-in 15 amp circuit breaker. This feature protects the unit from any electrical surges that may occur.

Can you fix an electric fireplace?

Branded electric fireplaces, like the ones that we carry at Stylish Fireplaces, can certainly be repaired outside of warranty. It’s one of our criteria for carrying a product line. All of the better brands provide parts so that the fireplaces may be repaired long after the warranty expires.

How much does it cost to repair an electric fireplace?

The national cost average to repair a fireplace is between $200 and $1,000. Most homeowners pay around $600 to repoint a damaged section of a brick fireplace….Cost to Repair a Fireplace by Source.

Type Average Costs (Labor Included)
Electric $150 – $900
Gas $200 – $1,000
Wood $200 – $1,200

Why is my fireplace heater not working?

Heater Stops Working While the fireplace is shut off, check for any obvious faulty wiring or an issue with the plug itself. Loose wiring can sometimes cause the logs to glow dimly. This involves simply repairing the wiring. If all looks good, plug the fireplace back in and start it up.

How to replace heater?

– Remove the screws connecting the vent pipe to the water heater using a screwdriver or nut driver. – Leave the old venting in place but check for rust or damage. Replace the flue pipe if it is in poor condition. – Remove the old water heater. – Dispose of your old water heater. – Clean the floor where the old water heater stood.

Does Handy heater really heat?

Handy Heater is an electric space heater which can heat a room up to 250 square feet. Featuring a digital timer and temperature control, we are told that plugging Handy Heater into any outlet will warm any room and save money on a heating bill.Handy Heater is quite small and offers a moderate 350 watts of power.

How to repair your heat surge fireplace?

Disconnect the power of the fireplace

  • Open the excess cover on the back of the fireplace unit
  • Make a replacement of the bulb (s) when they are burnt out
  • In case the motor that runs the rod fails to work,restore the motor if manageable
  • When the flame acts are squeaking at working,make the rod slippery
  • How to fix heat surge fireplace?

    Unplug fireplace from electrical outlet.

  • Let light bulbs cool for 15 minutes.
  • Remove front lower cover on front of fireplace below logs. Two screws must be removed.
  • Flame tube might be visible on left side.
  • Replace lower front cover.
  • Plug fireplace into electrical outlet.
  • Turn fireplace on.