What is SkyPower on JLG?

The JLG SkyPower® system delivers the power you need to conveniently operate other JLG accessories. With the SkyPower system on your machine, you get a 7500W generator with a power cable to the platform. Easily add and provide power to other JLG accessories, including SkyWelder® and SkyCutter® packages.

What is a SkyWelder?

Tucked into the SkyPower® boom platform, the 280-amp Miller® CSTTM 280 welder conserves space and provides stick and TIG capabilities. The SkyWelder® eliminates leads hanging over the rails, and eliminates the unnecessary cost of having a stand-alone welder and power supply.

How we can use lift buttons?

The two buttons available to call an elevator have an up arrow and a down arrow. These are meant to indicate whether you want to go up or down, not whether the elevator must come up or down. For example, if you’re on Floor 3 and you want to go to Floor 7, you need to press the Up arrow button.

How does a scissor mechanism work?

The scissor lift control system moves the hydraulic fluid or compressed air from the reservoir to the operating cylinders. The hydraulic cylinder pushes outwards for upward movement and causes the scissor legs to push apart, raising the platform.

How do you use a lift button up and down?

Rule #1: The two buttons available to call an elevator have an up arrow and a down arrow. These are meant to indicate whether you want to go up or down, not whether the elevator must come up or down. For example, if you’re on Floor 3 and you want to go to Floor 7, you need to press the Up arrow button.

How do you use a lift button inside?

If you are waiting for the elevator, there is sure to be an up and down button, depending on what floor you are on. If you are going up, push the top one, and when going down, push the bottom one. When inside the elevator, press the button for the floor you want to go to.

Which button should be pressed for lift?

ANS: You press the down button – you always press the button in the direction you want to go after you get into the lift. You never press the button based on how you want the lift to travel so that it comes to you.

How often do you change the oil in a JLG lift?

Oil Change w/Filter – GM Lube Point(s) – Fill Cap/Spin-on Element (JLG P/N 7027965) Capacity – 4.5 qt. (4.25 L) w/filter Lube – EO Interval – 3 Months or 150 hours of operation Comments – Check level daily/Change in accordance with engine manual. SECTION 6 – GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE 3121209 – JLG Lift –6-27 13.

What is the shutdown procedure for a JLG lift?

4-6– JLG Lift – 3121209 Shutdown Procedure IF AN ENGINE MALFUNCTION NECESSITATES UNSCHEDULED SHUTDOWN, DETERMINE AND CORRECT CAUSE BEFORE RESUMING ANY OPERATION. 1. Remove all load and allow engine to operate at low speed setting for 3-5 minutes; this allows for further reduction of internal engine temperature. 2.

What is the nomenclature of the JLG lift?

2-6– JLG Lift – 3121209 Figure 2-2. Machine Nomenclature – 800AJ (Sheet 2 of 2) ARTICULATING JIB ARTICULATING JIB LIFT CYLINDER ALL OTHER COMPONENTS ARE SIMILAR TO MODEL 800A ON PRECEDING PAGE

When to contact JLG Industries for an accident?

JLG INDUSTRIES, INC. MUST BE NOTIFIED IMMEDIATELY IN ALL INSTANCES WHERE JLG PRODUCTS HAVE BEEN INVOLVED IN AN ACCIDENT INVOLVING BODILY INJURY OR DEATH OF PERSONNEL OR WHEN SUBS TANTIAL DAMAGE HAS OCCURRED TO PER- SONAL PROPERTY OR THE JLG PRODUCT. Contact: