What is a rear axle housing?
A rear axle assembly is a very large and heavy piece of steel and iron that is used to propel the vehicle by converting rotational force into linear motion. The drive shaft sends rotational power from the engine and transmission to the rear axle assembly differential.
What is an axle housing?
Axle housing means the housing parts that are needed for structural capability as well as for carrying the driveline parts, bearings and sealings of the axle.
What are axle housings made of?
cast iron for center. Steel for everything else.
What is differential housing?
The differential housing is a critical element in the vehicle’s drivetrain, whose objective is to house differential gear assemblies and take torques coming from those gears.
How long does it take to change a rear end?
To just remove and re-install the entire assembly would require roughly 7 to 11 hours depending on exactly what your circumstances are and what is re-usable or will have to also be replaced.
What happens when the rear end goes out in a car?
Typically, when the gears wear out — or the bearings fail — the differential will start to howl. You’ll hear something that sounds like a deep whistling sound that goes up and down in pitch as you go faster and slower. Sometimes it’ll go away when you step on the gas.
What are the parts of an axle?
They have four main parts, which are the beam, the swivel pin, the track rod, and the stub axle. Front axles must be as sturdy as possible, and that’s why they’re usually made from carbon steel or nickel steel.
What type of axle housing resembles a banjo?
The overall shape of this type of axle housing (i.e., the generally round shape of the central member and the elongated tubes extending therefrom) generally resembles the shape of a banjo musical instrument. Hence, this type of axle housing is commonly referred to as a banjo type axle housing.
How long does it take to fix a rear axle?
If the axle, flange gasket, wheel bearings, brakes, wheel seal, and gear oil was replaced, then the time is 3.75 hours, which is 3 hours and 45 minutes, unless there was an issue with the axle being stuck in the axle housing or the s-cams needed new bushings.
What are the parts of a rear axle?
Rear Wheel & Axle Components
- Bolts and Nuts (Rear Wheel)
- Centre Housing & Components.
- Crown Wheel & Pinion.
- Differential.
- Independent PTO Clutch/Gears.
- Input Shafts.
- Rear Axle & more.
What is axle assembly?
Axle Assembly – This refers to the axle shafts that are found at the front of a FWD vehicle, and at the rear of an AWD car or SUV. They do not support any vehicle weight – they just transfer power from the engine to the wheel.
How long does it take to rebuild a rear end?
A complete rear differential replacement includes replacing the housing, gears, bearings, and seals. The average time it takes a certified mechanic to perform a differential rebuild at a shop is usually three to five hours.